Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
104
Appendix F: Hard Drive Installation
APPENDIX F: HARD DRIVE INSTALLATION
The system comes with one or more pre-installed 3.5" SATA hard drives. You can install up to two
hard drives up to a maximum size of 3TB each (for a maximum total storage of 6TB).
Installing a Hard Drive
To remove the hard drive:
1. Power off the system, and unplug all wiring / cabling from the system.
2. Remove the screws (4x) from the back panel. Slide the cover back and up to remove.
3. Insert hard drive screws (4x) on the hard drive and tighten them half way.
Insert hard drive screws
(4x) and tighten half way
4. Place the hard drive over one set of screw holes on the bottom panel with the SATA power and
data connectors facing the middle of the unit. Slide the hard drive into place.
Place hard drive over screw
holes and slide into place
Hard drive screw holes
Make sure that the system is OFF and ALL power adapters have been
disconnected before removing/installing the hard drive.