Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
22
Using the Main Menu
2. Copy the firmware to a blank USB flash
drive.
NOTE: Do not hav
e any folders on the USB
flash drive—just the firmware file.
3. Connect the USB flash drive to a USB port
on the
system.
4. Right-click and then select Ma
in
Menu>Info>Version.
5. Click Start to
update firmware. Wait for
the firmware upgrade to complete. Do not
remove the USB flash drive until the
upgrade process is complete or power off
the NVR during the upgrade process.
Online Users
The Online Users sub-menu shows a list of
users connected to the system using remote
devices. You may click Disconnect to
disconnect a user for up to 18 hours or click
Block to block a user from the system.
Remote Device Info
The Remote Device Info sub-menu shows
information about IP cameras connected to the
system, it contains the following tabs:
• Channel Status: Shows the IP address,
model number, and camera status.
• Connection Log: Search for camera status
logs, including user access to cameras.
• Net Load: Shows a graph of upload and
download traffic for your system.