Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
41
FLIR SyncroIP NVR Central Management Software
• Enter the DDNS information into the NVR.
• NVR must have access to the Internet or Local Area Network (LAN).
Installing FLIR SyncroIP NVR CMS
Install FLIR SyncroIP NVR CMS from the CD included with your NVR or by downloading it from
www.digimerge.com. It is recommended to visit www.digimerge.com for the latest software
versions.
To start the software:
• Double-click the FLIR SyncroIP NVR CMS icon ( ) on the desktop.
• Cl
ick Login.
NOTE: The CMS def
ault User Name is admin and the Password is admin.
Adding a NVR from the Local Area Network (LAN)
Once you open the software, you can add a NVR.
Prerequisites:
• Connect the NVR to a router or switch on the network.
• Install the CMS on a computer in the same LAN as the NVR.
Login