Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
48
FLIR SyncroIP NVR Central Management Software
5. Check video files to select and click Play to open.
OR, click Do
wnload to download the video files to the local computer.
OR, click To
AVI to convert the video files to AVI and save to your local computer.
NOTE: You must stop playback before you may download video files.
Playback Controls
Configuring Monitoring Tasks and Projects
Tasks are used to configure the CMS to automatically cycle through different channel
arrangements. Projects are used to automatically cycle through multiple tasks.
Configuring Tasks
1. Click Config Manager>Scheme Task Config.
2. Click Moni
tor Task.
Click Monitor Task
3. Click New.
4. Enter a Tas
k Name of your choice.
5. Under Windo
w, select the split-screen mode you would like to show in the task.
6. Under Monit
or Item, configure the following:
• Window: Select the display window you would like to configure.
Pause/play
Stop
Fast
Slow
Click and drag to select
playback time. Use the
top bar to select minutes
and the bottom to select
hours