Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
78
Mobile Connectivity
live video from the camera that detected motion.
Push notification
NOTE: Appearance of notifications may differ
depending on the model of your device
NOTE: Your cameras must have motion detection activated to receive push notifications. For
details on enabling motion detection, see “Motion” on page 28.
To enable Push Notifications:
1. From the Main menu, tap Push Config.
NOTE: If Push Config is not
shown, tap Add, check Push Config, and then return to the Main
Menu.
2. Tap the NVR you would like to configure.
Select the NVR
3. Tap Motion Detect and then check each channel you would like to receive push notifications
from.
Check channels to enble
push notifications