Instruction manual

-5--4-
MEASUREMENTS INSTALLATION
PACKAGING CONTENT
PARTS DESCRIPTION
Bullet package contains the following:
Camera in housing ---------------------------------1
Instruction guide (This Document) -------------1
Mounting screw pack ------------------------------1
Service Video Cable -------------------------------1
 SunshieldScrew(ttedtocamera) -------------1
Allen Key ----------------------------------------------1
1a) Loosen the thread nut with the included
allen key and turn the camera base
counter clockwise to remove it from the
camera mount.
1b) Mount the camera base to the surface.
NOTE: The camera base is compatible with
an Octagon junction box
2a) Attach camera back onto the camera
base by turning it counter clockwise.
2b) Tighten the thread nut to secure the
camera’s horizontal angle.
2c) Use a Phillips head screwdriver to
adjust the vertical viewing angle of the
camera.
3) Adjust lens zoom and focus turning the
two external adjustment screws located
on the underside of the camera.
Adjustmentcanbemadeusingngers,
orwithuseofaatheadscrewdriver.
4) OSD Settings and video test port are
accessed via the service access port
on the underside of the camera. Turn
counter-clockwise to remove the cap.
Note: Apply considerable pressure when
replacing the cap to keep camera
weather proof.
Zoom Adjust Service Access Pan / Tilt Adjustment 360 Rotate Rotate Lock
Thread Nut
Focus Adjust
Open Close
(D) Allen Key
47x17mm
(B) Fitting Screws
PA4 x 35mm 4pc
(A) Wall Plugs
S8 x 30mm 4pc
(C) Sunshield Screw
M5 Thread
1
2
3
4
CDS
298.6 mm
11.8"
100.9 mm
4.0"
101.5 mm
4.0"
88.0 mm
3.5"
b
C