Instruction manual

3. Program and Operation

3.1 Getting Started

Before installing and operating the dome camera, please read this Instruction Manual carefully.

This dome camera can be operated using two methods:

- Use hot keys [See Appendix]

- Use OSD Menu on the monitor

You should install and connect the dome to an interface device before using this operating guide.

See [2. Installation and Connection].

Once installed, apply power to the dome. The start-up screen is displayed on the monitor.

* Notice:

You must save changes in each sub-menu and edit menu. You may need to save

settings twice.

For example, after you set the position of a preset, you must save the position in the preset edit

window and then save changes in the Preset Setup menu again.

* Notice:

To stop an action or alarm, press [ESC] button or [96+Preset]. The dome goes to

manual mode or pauses temporarily (about 10sec in Alarm mode)

3.2.1 Acessing the Main Menu [95] + [Preset]/ [Menu]

When you use Pelco-D and Pelco-P protocol with your controller, you can access the main

menu on your monitor by pressing the key [95] + [Preset] or pressing and holding the

[Menu] key for 2 seconds.

These symbols refer to the following joystick actions:

: move joystick up and down

: move joystick left and right

: move joystick right

[Tele/Wide]: twist joystick clockwise or counter-clockwise for zooming

ned key.

3.2 Main Menu

: move joystick up and down to select items.

[Open]/ [Near]: move joystick right or press [Open] or [Near] to select sub-menus.

[Close]/[Far]: Exit Main Menu.

MAIN MENU

SYSTEM SETUP

DISPLAY SETUP

CAMERA SETUP

DOME MOTION

PRESET SETUP

PATTERN SETUP

TOUR SETUP

SCAN SETUP

ALARM SETUP

EXIT