Instruction manual

3. Program and Operation
3.3.4 Entering a Password
To prevent unauthorized changes to settings, you can enable password protection.
When password protection is enabled, you must enter the password to enter the Main Menu.
Passwords must be 4 characters long.
- Enter into {Main Menu}
- Select {System Setup} and select {Password} using the joystick
[
].
- Enter the current password (default: 0000) by moving the joystick left and right to highlight numbers
and press [Tele] to enter numbers.
* Note:
0000 is the default password.
3.4 Display Setup Menu
: move joystick up and down to select items.
: move joystick left and right to change settings.
[Open]/ [Near]: move joystick right to enter sub-menus.
[Close]/ [Far]: Exit current menu without saving changes.
3.4.1 Language
- Select {Display Setup} and highlight {Lanugage} using the joystick.
- If you want to use another language, move the joystick left and right to select.
Available Languages: English/Chinese/Russian/Spanish/German/Italian/French/Dutch.
19
PASSWORD
CURRENT : ...
ENABLE : DISABLE
NEW : ...
CONFIRM : ...
0123456789
-SET/CLEAR : (TELE/WIDE)
-EXIT : (FAR)
DISPLAY SETUP
OSD SETUP
PRIVACY ZONE
IMAGE SETUP
MOTION / FACE
LANGUAGE: ENGLISH
EXIT
- Highlight {Enable} and move the joystick left or right to select {Enable} to enable password protection.
Move the joystick down to enter the new password.
- Enter the New password by moving the joystick left and right to highlight numbers
and press [Tele] to enter numbers. Re-enter the New password under Confirm.
- Press [Far] to exit the menu and save changes.
- Enter into {Main Menu}