Instruction manual

3. Program and Operation
3.4.2 OSD Setup
OSD setup allows you to program how labels are displayed on the monitor.
Labels can be configured for Title, Dwell Time, Zoom ratio, Camera ID, Operation Mode
and PTZ Angle. Label position can be adjusted.
- Enter into {Main Menu}
- Select {Display Setup} and select {OSD Setup} using joystick [
]
- Press [Tele] button to edit the position of labels. Move the label with the joystick and
press [Far] to return to the OSD Setup menu.
- Move the joystick left or right [ ]
to enable/disable label display.
- Press [Open] button to save changes.
- Press [Close] button to return to the previous menu without saving changes.
3.4.3 Privacy Zone Setup
Privacy masks can be moved using pan and tilt controls using the joystick and re-sized using the
zoom controls [Tele/Wide]. Privacy masks stay in position when adjusting the camera pan/tilt
and change size when adjusting the zoom ratio. A maximum of 15 privacy mask zone can be
displayed.
- Enter into {Main Menu}
- Select {Display Setup} and then {Privacy Zone} using the joystick
[
].
- Move the joystick left or right to select a privacy mask ID[00~14] to edit.
- To program a privacy mask, select {Edit}, use the pan/tilt controls to move to a target, and use
the zoom controls [Tele/Wide] to adjust the mask size. Press [Near] to save the privacy mask.
- After editing a mask, you can use the {Width} and {Height} controls to adjust the size.
- Set {Display} to On to display the mask on the screen.
- Select {Clear} to delete a saved privacy mask.
- Press [Open] button to save settings.
- Press [Close] button to return to previous menu without saving.
20
OSD SETUP
LABEL POSITION : OFF
TIME : ON
ZOOM : OFF
ID : ON
MODE : ON
ANGLE : 3SEC
SAVE : OPEN
BACK : CLOSE
- CHANGE : (LEFT/RIGHT)
- TO SETUP : (TELE)
PRIVACY ZONE SETUP
PRIVACY.00 : NOT
USED
EDIT :
DISPLAY :
WIDTH :
HEIGHT :
CLEAR
SAVE : OPEN
BACK : CLOSE
-
CHANGE : (LEFT/LIGHT)
- TITLE - MODE -
- DTIME -
ERROR MSG
- EXIT : FAR
- ID -
ZOOM - ANGLE -
PRIVACY ZONE SETUP
PRESS MOVE KEY
SAVE : NEAR
EXIT : FAR
- Highlight labels using the joystick to configure:
A Privacy Zone allows you to program four-sided zones that cannot be viewed by operators.
It is recommended that you set the size of privacy masks to at least twice the height and width
of the object/area you would like to mask.