Instruction manual

3. Program and Operation
3.4.4 Image Setup
This menu allows you to mirror the image horizontally, vertically, or both.
- Enter into {Main Menu}
- Select {Display Setup} and then select {Image Setup} using the joystick[
].
- Highlight {Mirror} and select Normal, Horizontal, Vertical, or H/V (Horizontal and Vertical).
- Press [Open] button or use joystick to save settings
- Press [Close] button or use joystick to return to the previous menu without saving changes.
3.4.5 Motion Detection/Face Detection (MD/FD)
The camera can monitor the image for movement or faces. When triggered, it sends an alarm using
the OSD and/or Alarm Out. The sensitivity of motion/face detection can be adjusted between 0 and
15 (a greater sensitivity value means alarms will be triggered more easily).
* Note:
To stop alarms temporarily (about 10sec), press [ESC] button or [96+preset]. Face detection may
be triggered by objects that appear similar to human faces.
- Enter into {Main Menu}
- Select {Display Setup} and then {MD/FD} using the joystick.
- Highlight {MD/FD} and select Off, Motion-D, or Face-D to enable motion or face detection.
- Highlight {Alarm} and select OSD to have alarms appear on the OSD, Alarm Out to send an
alarm message, or OSD + Al. Out for both an OSD alert and Alarm Out message.
- Highlight {Sensitivity} and select a sensitivity between 0 and 15 (greater sensitivity means alarms
are triggered more easily).
- Highlight {ATime} and select the duration of alarms in seconds.
- Press [Open] or use the joystick to save settings.
- Press [Close] or use the joystick to return to the previous menu without saving changes.
21
IMAGE SETUP
MIRROR : NORMAL
SAVE : OPEN
BACK : CLOSE
MD/FD
MD/FD : OFF
SENSITIVITY :
ALARM :
ATIME :
SAVE : OPEN
BACK : CLOSE