Instruction manual

3. Program and Operation
3.6 Dome Motion Menu
/ : move joystick up and down to select items.
/ : move joystick left and right to change settings.
/ [Open]/ [Near]: move joystick right to enter sub-menus.
/ [Close]/ [Far]: move joystick to cancel or to exit current menu without saving changes.
3.6.1 General Setup
This menu controls general motion settings.
Power-up Action (Power-up Act.) is a function (preset, tour, pattern and scan) performed when the
power is re-cycled or after alarm action. The following settings are available. Set the dome
‘On’ to resume its prior activity.
- Use the joystick [ ] to select On/Off.
Turbo Speed enables/disables turbo speed for manual pan/tilt operations.
- Use the joystick [
] to select On/Off.
Preset Speed allows you to select the preset speed.
- Use the joystick to select {Preset Speed} and select Fast, Normal, or Slow.
- Press [Open] button or use joystick to save settings
- Press [Close] button or use joystick to return to the previous menu without saving changes.
25
DOME MOTION SETUP
GENERAL SETUP
MOTION SETUP
HOME ACTION
CALIBRATION
EXIT
GENERAL SETUP
POWER-UP ACT. : ON
TURBO SPEED : ON
PRESET SPEED : FAST
PRESET MASK : OFF
SAVE : OPEN
BACK : CLOSE
When Preset Mask is on, the camera will show a gray screen while moving between presets.
When each preset is reached, the camera shows the image for the duration of the dwell time.
- Use the joystick
to select {Preset Mask} and select On or Off.