Instruction manual

3. Program and Operation
3.6.2 Motion Setup
Proportional Pan/Tilt (Prop. Pan/Tilt) adjusts the manual pan/tilt speed according to the zoom level.
- Highlight {Prop. Pan/Tilt} and use the joystick to select On/Off.
Auto-Flip automatically reverses the image when the camera passes the top of the tilt arc
(90 degrees). This allows the camera to see objects with the correct orientation after tilting
more than 90 degrees.
- Highlight {Auto Flip} and use the joystick to select On/Off.
Over-Tilt restricts the vertical view angle to prevent the image being cut off by the dome housing.
- Highlight {Over Tilt} and use the joystick to select Mode 0 / Mode 1 / Mode 2.
3.6.3 Home Action Setup
Home Action allows you to set a default action (e.g. Preset, Tour, or Auto Scan) that the camera
will perform after the joystick control has been idle for a predetermined amount of time.
The idle time can be set from 1 minute to 60 minutes.
- Enter into {Main Menu}.
- Select {Dome Motion} and then {Home Action} using the joystick[ ].
- Highlight {Action} and selct Home, Preset, Scan, or Tour. If Home is selected, the camera will
return to the default home position (Pan 0˚ / Tilt 8˚) after the idle time.
- Highlight {Number} and select the desired Preset, Scan, or Tour.
- Highlight {Time} and select the idle time.
- Highlight {Mode} and select On/Off to enable/disable Home Action.
- Press [Open] button or use the joystick to save settings.
- Press [Close] button or use the joystick to return to the previous menu without saving changes.
* Note:
In order to call an action (Preset, Pattern, Tour or Scan), you must save Preset, Pattern, Tour,
or Scan
rst.
26
MOTION SETUP
PROP. PAN/TILT : ON
AUTO FILP : ON
OVER TILT : MODE 1
SAVE : OPEN
BACK : CLOSE
HOME ACTION SETUP
ACTION : HOME
NUMBER :
TIME : 010 MIN
MODE : OFF
SAVE : OPEN
BACK : CLOSE
- Press [Open] button or use the joystick to save settings.
- Press [Close] button or use the joystick to return to the previous menu without saving changes.