Instruction manual

3. Program and Operation
3.10 Auto Scan Setup
/ : move joystick up and down to select items.
/ : move joystick left and right to change settings.
/ [Open]/ [Near]: move joystick right to open sub-menus.
/ [Close]/ [Far]: move joystick to cancel or return to previous menu without saving changes.
An Auto Scan is a PTZ function that can be moves the camera from one position to another
position. The camera can save a maximum of 8 Auto Scans. Scan Speed can be adjusted from
1 ~ 35 degrees per second. Use the following steps to create an Auto Scan.
- Enter into {Main Menu}.
- Select {Scan Setup} using the joystick [ ].
- Highlight {No.} and select the number of the scan you would like to edit.
- Move the joystick to select the desired start position and press [Near] to save. Move the
joystick to the desired stop position and press [Near] to save.
Note: Mode represents one of the following:
- Coming/Going: Camera moves between start and stop position. Start and stop position
must be different.
- Endless: Camera scans in a circular pattern. Start and stop position must be identical.
Use the {Direct} setting to set the scan direction as CW (Clockwise) or CCW
(Counterclockwise).
- Highlight {Speed} and select the scan speed in degrees per second.
- Highlight {DTime} and select the scan dwell time.
- Press [Open] or use the joystick to save settings.
- Press [Close] or use the joystick to return to the previous menu without saving changes.
30
SCAN SETUP
NO. 001 : NOT USED
EDIT :
SPEED :
DTIME :
DIRECTION :
MODE :
CLEAR
SAVE : OPEN
BACK : CLOSE
START POSITION SETUP
PRESS MOVE KEY
SAVE : (NEAR)
BACK : (FAR)
STOP POSITION SETUP
PRESS MOVE KEY
SAVE : (NEAR)
BACK : (FAR)