Instruction manual

3. Program and Operation
3.11 Alarm Setup
/ : move joystick up and down to select items.
/ : move joystick left and right to change settings.
/ [Open]/ [Near]: move joystick right to ener sub-menus.
/ [Close]/ [Far]: move joystick to return to previous menu without saving changes.
- Enter into {Main Menu}.
- Select {Alarm Setup} using the joystick [ ].
- Highlight {No.} and select the number of the alarm you would like to configure.
- Highlight {In} and select the alarm input type: N.O. (Normally Open) or N.C. (Normally Closed).
- Highlight {Out} and select the alarm output: On/Off.
- Highlight {Priority} and set the alarm priority between 1 and 4.
- Highlight {Action} and select the type of action that the alarm will trigger: Off, Preset
Pattern, Scan, or Tour.
- Highlight {Number} and select the number of the action the alarm will trigger.
- Highlight {ATime} and select the Action (dwell) time:
Time Out (3~60 sec): This is activated during a selected dwell time when an alarm is triggered.
Momentary (On): When alarm is triggered, the camera will maintain alarm activation until
it is stopped manually ([ESC] button or [96+preset]).
- Press [Open] or use joystick to save settings.
- Press [Close] or use joystick to return to previous menu without saving settings.
* Note:
In order to call an action (Preset, Pattern, Tour or Scan), you must save the action first.
To pause alarms (about 10sec) temporarily, press [ESC] button or [96+preset]
31
ALARM SETUP
NO. 001 : NOT USED
IN :
OUT :
PRIORITY :
ACTION :
NUMBER :
ATIME :
SAVE : OPEN
BACK : CLOSE
- SET/CLEAR : (TELE/WIDE)
The Alarm Setup menu allows you to configure alarm inputs and outputs.