Specifications

Upgrade to New Control Board
ADDvantage-32 PLUS ● AC to DC Power Converter
12-15
TABLE 12-1. NEW DRIVE CONFIGURATION PARAMETERS
CONFIGURATION
PARAMETERS
FUNCTIONALITY
Y059: DPY L3 MODE Sets the data type to be displayed on line 3 of the
LCD display. Choices are: ANALOG, DIGITAL,
DIGITAL BIT or FAULT. If Y059 is set to
FAULT, then the top entry of the Fault FIFO will be
shown on line 3.
Y060: DPY L3 ANLG If line 3 display mode is set to ANALOG, this is the
analog value to display.
Y061: DPY L3 DGTL If line 3 display mode is set to DIGITAL, this is the
starting bit of 10 bits to display – in a 0/1 format. If
line 3 mode is set to DIGITAL BIT, then line 3 will
show the label of the digital point and indicate ON
or OFF.
Y062: DPY L4 MODE Sets the data type to be displayed on line 4 of the
LCD display. Choices are: ANALOG, DIGITAL,
DIGITAL BIT or FAULT. If
Y062 is set to FAULT,
then the top entry of the Fault FIFO will be shown
on line 4.
Y063: DPY L4 ANLG If line 4 display mode is set to ANALOG, this is the
analog value to display.
Y064: DPY L4 DGTL If line 4 display mode is set to DIGITAL, this is the
starting bit of 10 bits to display – in a 0/1 format. If
line 4 mode is set to DIGITAL BIT, then line 3 will
show the label of the digital point and indicate ON
or OFF.
Y065: ADD32 COMPT When set to DISABLE, the signal analyzer will be
able to collect a maximum of 8000 data points.
When set to ENABLE, the operation of the signal
analyzer will be restricted to collect a maximum of
only 1000 points of data.