User's Manual

MicroVu HD™ Operation Guide 860-00222-00 Rev A
Digital Ally, Inc. | Device Configuration – VuVault
2-3
Location
Below are the configuration items for localization which are provided to address
Date/Time settings and display formats.
Local Time Zone
The local time zone is used to adjust the device when synchronizing to the
Greenwich Mean Time. During device configuration, the local time from the PC
real time clock will be used, and Central Standard Time is set by default.
The date and time is set by the factory prior to shipment. However, you must
also enter the correct UTC offset when configuring the device so that the time
zone can be set properly. For example, USA Central Standard Time =UTC -6.
If using VuVault™, the date & time are automatically synced to your computer
during activation.
PST = Pacific Standard Time (UTC - 8 hours)
MST = Mountain Standard Time (UTC - 7 hours)
CST = Central Standard Time (UTC - 6 hours)
EST = Eastern Standard Time (UTC - 5 hours)
AST = Atlantic Standard Time (UTC - 4 hours)
ALST = Alaskan Standard Time (UTC - 9 hours)
HST = Hawaiian Standard Time (UTC - 10 hours)
Daylight Saving
When set to Yes, Daylight Saving setting time will be automatically adjusted for
the configured Local Time Zone. If this is disabled, time will not be adjusted for
Daylight Saving.
Settings: No, Yes [default]
Date Format
The date format displayed on the event recordings is selected through this
setting.
Settings: mm/dd/yy [default]; yy/mm/dd; dd/mm/yy
24 Hour Time
This time format allows the device to be configured in a 12-hour format or a
24-hour format.
Settings: No [default], Yes
Power
Power to the MicroVu HD is controlled through your vehicle’s ignition. There are no
manual controls for powering the unit on and off. When ignition is switched on, the boot-
up process will begin. The driver-facing status indicators will flash in sequence until boot-
up is complete. When the Blue LED is lit steadily the unit is in Standby and is ready for
use.
The Power operation is configurable and specifies how the MicroVu HD will operate when
the vehicle ignition is turned to the ON or OFF positions. Two parameters control the
power operation in order as follows:
Ignition Shutdown Timer
The Ignition Shutdown Timer specifies the amount of time the MicroVu HD remains
fully powered when the vehicle ignition goes from ON to OFF.
Settings: 0 to 50 minutes, 1 hr, 2 hrs, 4 hrs, 8 hrs, 12 hrs, 24 hrs, and Unlimited [default = 1 hour]