User`s manual

Finally, always use good quality, fresh tapes for all recordings, and if possible, monitor the

recording as it is being made.

3.3 Factory Preset Filter Descriptions

1CH MODE:

Notice that in 1CH MODE, only the LEFT (PRI) input gets processed. This signal is first fed through

the Limiter, which helps prevent the signal from distorting on overload.

The signal then enters the first stage 1CH Adaptive filter, which is configured as follows:

Table 2: 1CH MODE First Stage Factory Presets

Parameter Preset Value

Filter Size 1024 taps

Prediction Span Delay 2 samples

Adapt Rate 8

Adapt Mode Auto

Output Residue

Algorithm LMS

Crash Detect Enabled

After the first stage of filtering, the signal enters the second stage 1CH Adaptive filter, which is

configured as follows:

Figure 3: 1CH MODE Block Diagram