User`s manual

1CH•ST MODE:

Notice that in 1CH•ST MODE, both the LEFT (PRI) and RIGHT (REF) inputs get fed into the

processor. These are usually the stereo output signals from either a stereo microphone preamplifier

or a stereo body wire receiver.

The signals are first fed through the stereo Limiter, which helps prevent the signals from distorting

on overload. The Limiter internally “links” the two channels, such that an overload on either input

channel will cause the levels to be reduced equally on both channels. This maintains a proper stereo

effect on the two signals.

Each limited signal then enters its own 1CH Adaptive filter (two filters total). Each filter is configured

as follows:

Table 6: 1CH•ST MODE Factory Presets

Parameter Preset Value

Filter Size 1024 taps

Prediction Span Delay 2 samples

Adapt Rate 8

Adapt Mode Auto

Output Residue

Algorithm LMS

Crash Detect Enabled

Figure

: 1CH ST MODE Block Diagram