Technical data

ASTi DACS: Operation & Maintenance Manual (Version 4, Rev. B.1) www.asti-usa.com

Model Builder Utilities Installation

Boot the system up into DOS.

Insert the MODEL BUILDER UTILITIES INSTALLATION disk into the ﬂoppy drive.

Type:

install

Follow the directions displayed on the screen. When installation is complete, go to the next sec-

tion.

Software Protection and Options Selection Key Installation

Insert the ASTi Software Protection Key Disk into the ﬂoppy drive.

Type:

install

Follow the directions displayed on the screen. When installation is complete, go to the next sec-

tion.

Note: After installing Model Builder, MB Utilities and Options, press [ctrl]+[alt]+[del] to reboot.

Allow Model Builder to build the display.rez ﬁle before proceeding.

Custom Model Installation

Use the following procedure for installing ASTi supplied custom sound models when provided

with the DACS. If ASTi supplied custom sound models are not included with the system, proceed

to the next section.

Note: ASTi Custom Sound Model disks should always be installed after Model Builder Software

installation to ensure proper loading of sound models at boot up.

• Insert Disk 1 of Custom Model Disk set in drive A:.

• Change to the A: drive and type ‘Install’

• When installation is complete, remove the disk.

• Continue this process until all disks are installed.

When all Custom Model disks are installed, go to the next section.