Technical data

www.asti-usa.com ASTi DACS: Operation & Maintenance Manual (Version 4, Rev. B.1)
Copyright © 1999-2006 Advanced Simulation Technology inc. 65
Cell Routing Configuration File Installation
Use the following procedure for installing ASTi supplied cell routing configuration file(s). These
files will be required when control panels are attached to RIUs and ASTi state machines are part
of the overall system solution.
If this situation does not apply, proceed to the next section.
Note: Cell routing configuration files may also be included with custom model delivery instead of
on separate disks. Files should always be installed after Model Builder Software installation to
ensure proper loading of sound models at boot up.
• Insert Disk in drive A:.
• Change to the A: drive and type ‘Install’
• When installation is complete, remove the disk.
When installation is complete, go to the next section.
User Generated Model Installation
After all application software provided with the system has been installed, the user should at this
time install his/her own sound models, sound files, subdirectories, or other modifications.
Model Builder Software Updates
If you receive a Model Builder software update, follow the model builder installation procedures
listed in the Cold Start section above.
During installation both the root and C:\MBUILDER\BIN directories are saved to directories
ROOT.SAV and C:\MBUILDER\BIN.SAV If you have made changes to your autoexec.bat or
config.sys be aware that these files will be replaced by Model Builder’s standard autoexec.bat and
config.sys files during installation. You will need to update these files with your changes after
Model Builder is installed.
Note: Systems provided with ASTi custom sound models will require reinstallation of the model
disks AFTER Model Builder installation to ensure correct sound model loading at boot up.
(Reloading the model disks installs the correct autoexec.bat.)