User`s manual

Page 19
5.6.3 Audio Line Out Configuration
By default, the audio line outputs on the rear panel (labeled ANALOG OUTPUTS
and DIGITAL OUTPUT) always contain output audio. This default behavior
allows the user to toggle between input and output on the headphones without
affecting the line output.
However, it may at times be desirable to have the line outputs toggle along with
the headphones. To make this possible, a “Toggle Line Out with Headphones”
option is available in the Channels menu, as shown in Figure 5-10.
Figure 5-10: Toggle Line Out with Headphones
When this item is checked, the INPUT/OUTPUT button on the front panel toggles
both the headphones and the rear-panel outputs. When the item is unchecked,
only the headphones toggle and the rear-panel outputs always contain output
audio.
5.7 Storing Configurations
With the MicroDAC 5 software you can store configurations into files on your
PC’s hard drive for later recall and reuse. These files contain the settings for the
configuration including system bandwidth, channel configuration and filter
settings.
The adapt/freeze settings are not stored in the configuration files, because
storage of adaptive filter coefficients is not supported. New configurations