User's Manual

Battery Pack and Charger
12 DigiTrak
®
F5
®
Operator’s Manual
DCI F Series Battery Charger
with F Series Battery Pack
Supply Power to the Battery Charger:
Install either the AC adapter or DC power
cord’s charger plug into the battery charger
power port by inserting it as shown to the right
and rotating it a quarter of a turn to secure.
- If using AC power, connect the AC
power cord to the AC adapter and then
plug the cord into an AC power
receptacle (wall outlet, 100–240 V, 50–
60 Hz, 1500 mA max).
- If using the DC power cord, plug it
directly into the DC power source (12
V, 5000 mA max).
- Once powered, the orange LED on the
battery charger will begin to flash.
DCI F Series Battery Charger
Charging a Battery Pack
Only use F Series battery packs with the F Series
battery charger. Power must be supplied to the
battery charger, as indicated by the flashing orange
LED, before charging a battery.
To begin charging, install the battery pack into the
charger with the orientation shown below.
The battery pack is properly installed when the red
LED on the battery charger illuminates indicating
active charging. The level of charge on the battery
pack is indicated throughout the charging cycle by
the green LEDs on the battery pack. When the
battery is done charging, all of the LEDs on the
battery pack will briefly illuminate and battery
charger’s green LED illuminates.
Battery Charger LED Indicators
The battery charger has three LEDs (red, orange, and green) that are on, off, or flashing, depending on
the charger status. The chart below summarizes the charger status indicated by the various LED settings,
including the battery’s status, where applicable, and the charge time.
Green
LED
Orange
LED
Red LED
Charger Plug
Power Port
Push to Secure