User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- F Series Battery Charger System
- Receiver
- General Description
- Standard Receiver Display Screen Symbols
- /Power On
- Power Off
- Automatic Shutdown
- Toggle & Trigger Switches
- Audible Tones
- Main Menu
- /Calibration Menu
- /Height-Above-Ground (HAG) Menu
- /Settings Menu
- Transmitter Selection Menu
- /DigiTrak LWD (Log While Drilling) Menus
- Target Steering Menu
- Using the Keypad
- Display Screens
- Transmitter
- Remote Display
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- Appendix E: EU Required Documentation
- LIMITED WARRANTY
Receiver
DigiTrak
®
F5
®
Operator’s Manual 17
Inserting Battery Pack
Power On
Install a charged battery pack as shown to the right ensuring the tab latches
the battery in place.
Pull in and hold the trigger switch for at least two full seconds to turn on the
receiver. A splash screen will display while the receiver performs it’s self-test.
The warning screen shown below will then display.
Warning Screen
Pull and release (click) the trigger switch to indicate that you have read and understand this manual.
If all items of the self-test passed, the startup screen shown below will display.
F5 Start Up Screen
Regional
Designation
Number (Must
Match that of
Transmitter)
System Name
Serial Number
Software
Version
Web Address
Customer
Service Phone
Numbers