User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- F Series Battery Charger System
- Receiver
- General Description
- Standard Receiver Display Screen Symbols
- /Power On
- Power Off
- Automatic Shutdown
- Toggle & Trigger Switches
- Audible Tones
- Main Menu
- /Calibration Menu
- /Height-Above-Ground (HAG) Menu
- /Settings Menu
- Transmitter Selection Menu
- /DigiTrak LWD (Log While Drilling) Menus
- Target Steering Menu
- Using the Keypad
- Display Screens
- Transmitter
- Remote Display
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- Appendix E: EU Required Documentation
- LIMITED WARRANTY
Receiver
40 DigiTrak
®
F5
®
Operator’s Manual
Depth Display Screen, No Data
The depth screen can be accessed at any time during locating by holding in the trigger. However, depth
or predicted depth data will only be displayed when the receiver is at the locate line or locate points,
respectively. The depth screen will display as follows when the receiver is not positioned at a locate point
or the locate line.
Receiver Depth Screen (when not at the LL or LP)
If HAG were enabled, the receiver would be shown elevated above the ground and the HAG value would
display below the receiver.
Locate Mode Screen with Pressure Transmitter
When a pressure transmitter is used, the locate mode screen has an additional field as shown below.
Slanted Line In-
dicates Receiver
Is Not at FLP,
RLP, or LL.