User's Manual

Transmitter
42 DigiTrak
®
F5
®
Operator’s Manual
The extended long-range transmitters provide a depth range of approximately 85 ft (25.9 m). They
measure 19 in. (48.26 cm) long and 1.25 in. (3.175 cm) in diameter. They have an extended transmitting
range and are available in 12 kHz (grey) or 19 kHz (black).
The short-range FS transmitter provides a depth range of approximately 15 ft (4.6 m). It measures 8 in.
(20.32 cm) long and 1.00 in. (2.54 cm) in diameter.
Short-Range FS Transmitter with Closeup of Front End Cap
The FC cable transmitter provides a depth range of approximately 90 ft (27.4 m). It measures 19 in.
(48.26 cm) long and 1.25 in. (3.175 cm) in diameter.
FC Cable Transmitter
This transmitter requires a special rear-load housing with an end plug that allows the transmitter’s cable
to exit the housing. The end plug requires a compression fitting to seal the transmitter from the drilling
fluid. For operational information on the FC cable transmitter, please see the DigiTrak Multi-Function
Cable Box (MFCB) Operator's Manual.
NOTE: The range of any transmitter is largely dependent upon the amount of interference at a job
site. The range decreases as interference increases. More transmitter frequency options an
power options means more options for overcoming jobsite interference.
Batteries and Power On/Off
The long-range transmitters each require two C-cell alkaline batteries or one DCI SuperCell Lithium
Battery. The extended long-range transmitters require one DCI SuperCell battery. Do not use alkaline
batteries in the FXL transmitter; they would last only a few hours. The short-range FS transmitter requires
one AA alkaline battery.
NOTE: Never use damaged or non-DCI lithium batteries. DCI SuperCell batteries are manufactured to
military specifications. The use of damaged or lower-quality lithium batteries may damage the
transmitter and/or housing and will void the DCI warranty.
Regional
Designation
Number
Front End Cap
Index Slot
Temp Dot