User's Manual

Quick Start Guide

14 Eclipse

TensiTrak

Operator’s Manual

To power up the TensiTrak unit using the SuperCell lithium battery, insert it positive terminal first, followed

by a spacer or dummy battery (positive terminal first), as shown below. You must use a spacer or a

dummy battery behind the SuperCell battery to take up space and provide the necessary ground

connection. Do not use a C-cell battery as a spacer or dummy battery.

Loading SuperCell Lithium Battery and Spacer in TensiTrak Unit

Setting up Receiver and Remote Display

Power up the remote display and receiver, and select Tension mode on both. Verify that live data is

displayed on both; if not, verify that both are set to the same telemetry channel and option mode.

Verify that the Job Number shows as 1. If this is not the first job, then you will need to change the Job

Number. To do so, from the main menu screen select DataLog | Tension DataLog | Change Job

Number.

Verify that there are no data points.

Receiver Display Screen

Data Point

Number

Signal

Strength

Telemetry

Channel

Leading End (with

Battery Compartment)

Trailing End (with

Mud Pressure Sensor)

Install SuperCell

Battery and Spacer

Space

SuperCell Battery