User's Manual

Quick Start Guide
18 Eclipse
®
TensiTrak
®
Operator’s Manual
NOTE: If there is no live data being received from the TensiTrak unit or if the unit is out of range,
the data point counter and the beeper will stop.
SUGGESTION: Because the TensiTrak unit creates a time-based graph, it is recommended that
you document corresponding site conditions for data points. For example, you
might save information such as “data point 300 was 100 ft (30.5 m) into the
pullback.”
Monitoring Used Memory
The receiver can save approximately 30 hours of TensiTrak data or approximately five runs before the
memory is full. When the receiver is in Tension mode and it is actively saving data, it displays the amount
of used memory as a percentage. You can view the used memory by holding the trigger in.
456.5
CH : B1
75
o
F
Used Memory: 12.0 %
3944
S
-
+
o‘ o’’
17’6’’
14.9
+
–
Receiver Display Screen Showing Used Memory
Used
Memory
Receiver
Battery
Status
Receiver
Battery Voltage
Remaining
Transmitter
Battery Status
(Shown Full)