User's Manual

Recording Data
28 Eclipse
®
TensiTrak
®
Operator’s Manual
Saving Data (Receiver)
1. Start Receiver’s Data Saving Mode
When you are ready for the installation to begin, you will start the receiver’s saving mode. First, be sure
that the remote display is powered up.
1. Select Tension from the main menu screen.
2. Toggle up and select Y for yes at the Start Data Saving dialog box.
NOTE: If it is not necessary to transfer the data to a computer, then you do not need to save
the data.
Start Data Saving Dialog Box
3. Verify that the letter S for saving appears on the right side of the screen. Also observe the
number above the thermometer; this is the data point. This number will increase by one every
3 seconds. The receiver will beep when this occurs to confirm active data saving. You may want
to document this number and the corresponding site conditions for comparison after transferring
the data to the computer.