User's Manual

Receiver
20 DigiTrak
®
F5™ Operator’s Manual
• Toggle to highlight the “0” then click the trigger to select it.
• Toggle to highlight the “2” then click the trigger to select it.
• Toggle to highlight the “1” then click the trigger to select it.
• Toggle to highlight the “1” then click the trigger to select it.
3. Confirm that the date reads as desired.
4. Toggle to highlight the return arrow and click the trigger to select it. The confirmation signal will sound
as the screen returns to the settings menu with the exit option highlighted.
Telemetry Channel Menu
The telemetry channel menu has five telemetry settings (1, 2, 3, 4, and 0) and an exit option. The current
setting is automatically highlighted for selection when the telemetry channel menu is accessed. For
communication to occur between the receiver and remote display, both devices must be set to the same
telemetry channel.
To change the telemetry channel on the receiver, use the toggle switch to highlight the desired telemetry
channel in the telemetry channel menu, then click the trigger. The confirmation signal will sound as the
screen returns to the settings menu.
Selecting the exit option will return the screen to the settings menu with no change to the telemetry
channel setting. Selecting “0” will turn off the telemetry function, which conserves battery life in the
receiver.
Roll Offset Menu
Roll offset is needed when the 12 o’clock position of the transmitter cannot be indexed to that of the drill
head. It allows you to program the receiver to display the roll of the drill head rather than that of the
transmitter. The roll offset menu has options to set and enable roll offset or to disable roll offset, as shown
below. See “Set Roll Offset” in the System Setup section for complete instructions on using the roll offset
menu.
Roll Offset Menu
Disable roll offset
Exit
Enable roll offset
(shown highlighted)