User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- General Description
- Toggle and Trigger Switches
- Audible Tones
- Installing and Removing the Battery Pack
- Power On
- Power Off
- Main Menu
- Locate Mode
- Calibration Menu
- Height-Above-Ground (HAG) Menu
- Settings Menu
- Transmitter Selection Menu
- Drill DataLog Menu
- Pressure-Tension DataLog Menu
- Using the Keypad
- Display Screens
- Standard Receiver Display Screen Symbols
- Transmitter
- Remote Display
- Battery Charger
- System Setup
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- LIMITED WARRANTY
Receiver
24 DigiTrak
®
F5™ Operator’s Manual
Select either the create new job or append existing job option, and the display will return to the locate
mode screen with data being recorded under the specified job number. When P-T data is being recorded,
the recording icon
will appear to the lower right of the transmitter roll indicator. If you select exit
from the P-T recording menu, the display will return to the locate mode screen with data recording turned
off. When the system is not recording but still has the P-T DataLog function enabled, toggling right from
the locate mode screen will open the P-T recording menu again so that you can start recording when
desired.
With a P-T job recording, toggling right from the locate mode screen will open the flag recording menu
shown below.
DataLog Flag Recording Menu
Flags may be recorded at fixed intervals and at critical points along the bore path, such as before and
after crossing under a roadway or stream, for future reference when editing and analyzing the data.
Complete instructions for using the pressure-tension DataLog function and the accompanying LWD
software are provided in the DigiTrak LWD DataLog System Operator’s Manual.
Exit (returns to locate
mode screen with no
new flag recorded)
Set a flag (records
flag number
indicated on locate
mode screen)