User's Manual

Receiver
DigiTrak
®
F5™ Operator’s Manual 25
Using the Keypad
A keypad is provided in several menus for entering values at the receiver. It is used for setting the height-
above-ground value in the HAG function, setting a target depth in the Target Steering function, and
programming rod lengths and a survey point in the DataLog function. A variation of the keypad is used to
set the date and time when using the DataLog function, as discussed above under the “Settings Menu.”
The standard keypad appears when the keypad icon is selected. The receiver units may be set to meters
(x.xx m), feet only (x.xx’), feet and inches (x’xx”), or inches only (xx”); the inches only setting is shown in
the example below.
Standard Keypad
To input a value, use the toggle switch to highlight the number you want to select, then click the trigger to
select it. Do this for each digit from left to right. When a decimal value is required (such as for feet only or
meters), then the last two digits entered will be to the right of the decimal point. If a whole value is desired
in this case, then enter two zeros at the end of the value. To delete the last digit entered, select the
backspace key. Once the desired number is in the display window, toggle to highlight the return arrow
and click the trigger to lock in the value and turn on the function.
Return arrow
(shown highlighted
for selection)
Display window
Exit (returns to
main menu)
Backspace