User's Manual
Table Of Contents
- FCC Compliance Statement
- This equipment complies with Part 15 of the Rules of the FCC. Operation is subject to the following two conditions: (1) this equipment may not cause harmful interference, and (2) this equipment must accept any interference received, including interfer...
- Table of Contents
- Safety Precautions and Warnings
- Introduction
- Power Setup
- Cable Mode
- Appendix A: System Specifications and Maintenance Requirements
- LIMITED WARRANTY
Multi-Function Cable Box
DigiTrak
®
MFCB™ Operator’s Manual 11
Once the ground connection is achieved, the cable transmitter is powered through the DCI cable-box as
shown below.
Cable Transmitter Powered through Cable-Box
Install the cable from the transmitter by rotating the knob on the cable-box counterclockwise until the hole
in the power post is exposed. Insert the stripped portion of the cable into the hole and gently tighten the
knob by rotating it clockwise to secure. When a Steering Tool used, the computer connection is made
through the SST serial cable port.
The complete cable system setup is given in the following diagram.
Knob
Power Post
SST Serial
Cable Port
Cable to Transmitter