User's Manual
Table Of Contents
- FCC Compliance Statement
- This equipment complies with Part 15 of the Rules of the FCC. Operation is subject to the following two conditions: (1) this equipment may not cause harmful interference, and (2) this equipment must accept any interference received, including interfer...
- Table of Contents
- Safety Precautions and Warnings
- Introduction
- Power Setup
- Cable Mode
- Appendix A: System Specifications and Maintenance Requirements
- LIMITED WARRANTY
Cable Mode
DigiTrak
®
MFCB™ Operator’s Manual 15
remote will display the transmitter’s heading or “yaw” at the bottom of the screen, shown above. The
reference yaw must be programmed to this value. Program the reference yaw in the Reference Yaw
Menu as described below.
Reference Yaw Menu
From the Eclipse SST Main Display, press the up direction button, , on the MFD or FSD to access
the Reference Yaw Menu.
Reference Yaw Menu
There are three options in the reference yaw menu as described above. Use the direction buttons to
highlight the desired option and press the execute button to select it.
When the Set option has been selected, you will be returned to the SST Main Display with the new
reference yaw displayed.
When the Keypad has been selected, the following screen will display.
“Set” programs the
displayed (actual
SST yaw) value as
the reference yaw
Exit (highlighted)
exits the menu
with no change
Keypad allows the
reference yaw to be
entered manually
Actual SST Yaw