User's Manual
Table Of Contents
- FCC Compliance Statement
- This equipment complies with Part 15 of the Rules of the FCC. Operation is subject to the following two conditions: (1) this equipment may not cause harmful interference, and (2) this equipment must accept any interference received, including interfer...
- Table of Contents
- Safety Precautions and Warnings
- Introduction
- Power Setup
- Cable Mode
- Appendix A: System Specifications and Maintenance Requirements
- LIMITED WARRANTY
Cable Mode
DigiTrak
®
MFCB™ Operator’s Manual 17
Target Steering
When a target depth has been programmed into the receiver and the remote is receiving telemetry data,
the following screen will display.
SST Target Steering Display
If a standard Eclipse Cable transmitter is used, the screen will display as above but without the yaw data
and the roll will display by clock position as opposed to the 360⁰ indicator shown here. See the Target
Steering Display in the Remote Mode section.
Roll Offset
The roll offset function is only available in cable-mode. It is used when the transmitter’s 12 o’clock slot
does not match the drill head’s 12 o’clock position.
To access the roll offset menu, push the right direction button,
, from the Eclipse Cable or SST Main
Display. The Roll Offset Menu will appear.
SST’s Deviation from
Reference Yaw
Actual SST Yaw