User's Manual
Table Of Contents
- FCC Compliance Statement
- This equipment complies with Part 15 of the Rules of the FCC. Operation is subject to the following two conditions: (1) this equipment may not cause harmful interference, and (2) this equipment must accept any interference received, including interfer...
- Table of Contents
- Safety Precautions and Warnings
- Introduction
- Power Setup
- Cable Mode
- Appendix A: System Specifications and Maintenance Requirements
- LIMITED WARRANTY
Cable Mode
18 DigiTrak
®
MFCB™ Operator’s Manual
Roll Offset Menu (Enable)
There are three options in the roll offset menu as described above. Use the direction buttons to highlight
the desired option and the execute button to select it.
Once the roll offset is programmed, the following screen will display if using the Eclipse Cable transmitter.
Eclipse Cable Mode Screen with Roll Offset
The roll offset will remain active until you access the roll offset menu and disable it.
When roll offset is active and the Roll Offset Menu is accessed by pressing the right directional button,
the following screen will display.
Transmitter’s 12
o’clock position
“Set” programs the
displayed value as
the roll offset
Exit (highlighted)
exits the menu
with no change
“Go” activates roll
offset to the value
most recently set
Fixed mark
denoting drill
head’s 12 o’clock
position
Drill head’s 12 o’clock
Offset to transmitter’s
12 o’clock index slot