User's Manual

Getting Started
DigiTrak
®
F5 User Guide 16
Power On
1. Remove the battery cap from the transmitter.
2. Insert battery or batteries positive terminal first as shown.
Install Transmitter Batteries Positive Terminal First
3. Replace the battery cap.
Use the F5 receiver to verify data from the transmitter. All
readings should be stable unless the transmitter or receiver is
moved. If there is a problem, verify the regional designation
number on the transmitter matches that displayed on the
receiver’s startup screen or call DCI for support.
Sleep Mode (Automatic Shutdown)
The transmitter is programmed to stop broadcasting and go
into a battery conserving sleep mode after 15 minutes of no
rotation. To wake the transmitter, rotate the drill stem.
Transmitter Battery Status
When using alkaline batteries, the battery status symbol,
shown above, indicates the battery life remaining.
NOTE: The SuperCell battery will appear to be full until
just before it dies. You must track the hours of
use for the SuperCell battery.
C-Cell C-Cell
SuperCell™