User's Manual

Getting Started
DigiTrak
®
F5 User Guide 20
Power On
Press the execute button for a half second or more to
turn on the FSD remote. You will hear a tone and the main
display screen will appear.
If a transmitter and receiver are powered on, the locating data
should display. If no locating data displays, verify the
receiver is displaying locating data and that the receiver and
remote are set to the same telemetry channel. See
Navigating Menus for more information on setting the
telemetry channels.
Adjusting Screen Contrast
With the FSD remote powered on, hold in the execute button
while pushing the right arrow (to lighten the display) or the left
arrow (to darken the display). Each push of the right or left
arrow will change the contrast incrementally.
Adjusting Viewing Angle
The FSD remote allows you to adjust the viewing angle
through a range of 180° left/right, 90° up/down, and 270°
about the display’s center.
Up/Down – Loosen and squeeze together the two knobs on
the back of the remote display. Then adjust the screen as
desired and tighten the knobs. If the knobs are loose, the
display will hold its vertical position only until the knobs are
squeezed together or the display is vibrated. Thus, DCI
recommends tightening the knobs before drilling.
Left/Right – With the FSD remote’s magnetic base secure,
grasp the top portion of the display and rotate it about the
base to the desired orientation.
Center – With the FSD remote’s magnetic base secure,
grasp the top portion of the display and rotate it about the
center of the screen to the desired orientation.