User's Manual
Table Of Contents
- Important Safety Instructions
- Getting Started
- Receiver
- Receiver Menus
- Locating Basics
- Advanced Locating
- Transmitter
- Appendix A: System Specifications
- Appendix B: Receiver Screen Symbols
- Appendix C: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix D: Calculating Depth Based on Distance Between FLP and RLP
- Appendix E: Reference Tables
DIGITALCONTROLINCORPORATED
20 DigiTrak Falcon F5
®
Operator's Manual
Settings
Use this menu to set the following options:
1. Depth Units
2. Pitch Units
3. Date/Time
4. Telemetry Channel
5. Roll Offset
6. Pressure Units
7. Second page
8. Temperature Units
9. Language
Settings Menus
DCI recommends that you program the receiver and the remote display Depth and Pitch settings to use the
same units of measure.
Depth Units Menu
Choose between xx" inches, x'xx" feet and inches, x.xx' decimal feet, and x.xx m metric units (meters and
centimeters).
Pitch Units Menu
Choose between degrees (x°) and percent (x%). Typical HDD bores use percent pitch instead of degrees.