User's Manual

DIGITALCONTROLINCORPORATED
DigiTrak Falcon F5
®
Operator's Manual 21
Set Time and Calendar Menu
Set the time and date on your receiver. This is necessary when you are using the DataLog function.
1. Time value (date displays
here when calendar is the
active function)
2. Time (shown active)
3. Calendar
4. Enter
Time and Calendar Keypad
Setting the Time
The time function runs on a 24-hour clock. To set the time:
1.
Select the time icon so it is the active function .
2. Enter the time one digit at a time from left to right. For example, to set the clock to 13:39 (1:39 pm),
select “1”, then 3, 3, and 9.
3. Select the blue Enter arrow.
Setting the Calendar
The calendar function displays the date by month/day/year. To set the date:
1.
Select the calendar icon so it is the active function . The display window on the keypad
changes to show a date format.
2. Enter the date one digit at a time from left to right. The date format is MM/DD/YYYY. For example,
to set the date to January 2, 2016 (01/02/2016), select “0”, then 1, 0, 2, 2, 0, 1, and 6.
3. Select the blue Enter arrow.
Telemetry Channel Menu
This menu has five telemetry channel settings (1, 2, 3, 4, and 0). For communication to occur between the
receiver and remote display, both devices must be set to the same telemetry channel.The current telemetry
setting is highlighted when this menu opens.
Select the desired telemetry channel on the receiver. To turn telemetry off and conserve receiver battery life,
select “0”. Channel 0 is also used when there are more than four receivers operating in the same area; using
more than one receiver per channel within telemetry range of each other will cause conflicting signals to be
sent to the remote display on the drill rig.