User's Manual
Table Of Contents
- Important Safety Instructions
- Getting Started
- Receiver
- Receiver Menus
- Locating Basics
- Advanced Locating
- Transmitter
- Appendix A: System Specifications
- Appendix B: Receiver Screen Symbols
- Appendix C: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix D: Calculating Depth Based on Distance Between FLP and RLP
- Appendix E: Reference Tables
DIGITALCONTROLINCORPORATED
DigiTrak Falcon F5
®
Operator's Manual 59
Never use damaged or non-DCI lithium batteries. Never use two C-cell lithium batteries providing a
combined voltage above 3.6 VDC.
DCI SuperCell lithium batteries are manufactured to military specifications. The use of damaged or
lower-quality lithium batteries may damage the transmitter and/or housing and will void the DCI
warranty.
Installing Batteries / Power On
DCI transmitters power on as soon as the batteries and battery cap are properly installed. To install the
batteries:
1. Remove the battery cap from the transmitter using a large slotted screwdriver or coin and rotating
counterclockwise.
2. Insert the battery or batteries into the transmitter with the positive terminals first. When using two
C-cell batteries, include the battery contact spring that came with the transmitter as shown below:
1. Battery cap
2. Battery (2)
3. Battery contact spring
4. Housing
C-Cell Batteries Installed with Battery Contact
Spring
Do NOT use the battery contact spring at either end of a single SuperCell
™
battery.