User's Manual

Introduction
10 DigiTrak
®
SE™ Operator’s Manual
The SE system is programmed to comply with varying global operating requirements. The receiver’s
regional designation number must match that of the transmitter for proper communication (see figure
showing startup screen in Receiver section and photo of ST transmitter in Transmitter section). Also, the
receiver’s telemetry frequency designation must match that of the remote display being used.
Appendix A presents the SE system’s power, environmental, and maintenance requirements. Appendix B
explains how to calculate depth when the transmitter is deep (greater than 15 ft or 4.6 m) and/or at a
steep pitch (greater than ±30% or ±17°). Appendix C explains how to calculate the transmitter depth
based on the distance between the front and rear locate points and the pitch of the transmitter. Finally,
Appendix D provides reference tables for depth and pitch conversions.