User's Manual

DIGITAL CONTROL INCORPORATED
DigiTrak
®
SE™ Operator’s Manual 11
Receiver
SE Receiver – Side View
General Description
The SE receiver is a handheld unit used for locating and tracking an SE transmitter. The receiver
converts signals from the transmitter and displays the following transmitter information: depth, pitch, roll,
temperature, and battery level. The SE receiver then sends this information to the remote display at the
drill rig.
To meet regional requirements and for proper communication, the telemetry frequency designation for the
receiver must match that for the remote display. The telemetry frequency designation is identified on the
receiver’s serial number label, which is located inside the battery compartment. It must match one of
those listed on the remote display’s serial number label located on the back of the unit.
The receiver and transmitter must also be able to communicate properly in different global regions. A
regional designation number is provided in the receiver’s software (see figure titled "Receiver Startup
Screen" later in this section). This number must match that stamped on the transmitter for proper
communication (see photo of ST transmitter in Transmitter section).
Trigger Switch
Front
Panel
Boot
Battery
Tab
Display
Screen
Handle
Grip
Battery
Compartment