User's Manual

Receiver
12 DigiTrak
®
SE™ Operator’s Manual
Power On/Off
Installing and Removing the Battery Pack
Insert a fully charged DCI NiMH or lithium-ion battery pack so that it is flush with the back of the receiver and
the tab is securely latched, as shown below. If necessary, push on the battery pack to latch the tab in place.
Inserting Battery Pack Battery Pack Fully Inserted Removing Battery Pack
To remove the battery pack, push down on the battery tab and pull it away from the unit until the tab is
released. Then grasp the battery firmly and lift it out of the battery compartment.
NOTE: Although the SE receiver can accept a DCI lithium-ion battery pack, the lithium-ion battery
pack cannot be charged in the DCI NiMH battery charger.
Turning On the Receiver
To turn on the SE receiver once the battery is properly installed, pull and hold in the trigger for 1 second,
and then release it. You will hear a short beep followed by a long beep. The first screen you will see is the
warning screen, which will appear every time you turn on the unit.
Receiver Warning Screen
Tab