User's Manual

Receiver
DigiTrak
®
SE™ Operator’s Manual 15
Trigger Switch
The SE receiver operates with a single trigger switch. The trigger switch is used to turn on the unit, adjust
the screen contrast, access and select menu options, as well as to change the screen view for depth
measurements. Clicking the trigger versus holding the trigger will result in different actions.
Click – Quickly pulling and releasing the trigger (in less than 1 second). From the locate mode screen, a
single click accesses the main menu, and then each subsequent click advances through the menu
options.
Hold – Holding the trigger in for more than 1 second. This action adjusts the screen contrast, selects a
menu option, or changes the display view for depth readings.
If the receiver does not sense any trigger action within a few seconds of entering a menu, then the display
returns to the locate mode screen.
Audible Tones
The SE receiver gives audible tones to signal power on/off, menu changes, and the pass/fail status of
actions, as summarized below. The receiver also emits tones with transmitter temperature increases (see
“Transmitter Temperature Warning Tones” in the Transmitter section).
Power On – One short beep followed by a long beep.
Power Off – Four long beeps.
Confirmation Signal – Four short beeps to confirm menu selection has been successfully executed.
Failure Signal – Two long beeps to indicate a problem with the menu item selected. A failure screen will
appear. The failure screen will display until the trigger is clicked.
Adjusting Screen Contrast
The screen constrast will automatically adjust for optimum viewing
in the existing light conditions immediately after turning on the re-
ceiver. It will take about 30 seconds for the adjustment to stablize.
To manually adjust the screen contrast, hold the trigger in with the
receiver held vertical and in locate mode. Release the trigger when
the screen contrast is adjusted to the desired level.
Main Menu
The main menu allows you to set the desired depth units, pitch units, roll offset, and height-above-ground
(HAG) distance; to select telemetry options; to calibrate the receiver to the transmitter; to use the remote
steering function; and to turn off the receiver. To access the main menu, click the trigger from the locate
mode screen. You will see six menu options, with the first one, the HAG menu, highlighted for selection.