User's Manual

ManualsBrandsDigital Control ManualsElectronicsET, ST, LT, LT2

DIGITAL CONTROL INCORPORATED

2 DigiTrak

SE™ Operator’s Manual

3-4200-00-A

68BTrademarks

The DCI logo, CableLink

, DataLog

, DigiTrak

, Eclipse

, F2

, iGPS

, MFD

SST

, target-in-the-box

Target Steering

, and TensiTrak

are U.S. registered trademarks and DucTrak™, F Series™, FSD™,

SE™, FasTrak™, LT™, LT2™, SuperCell™, and TeleLock™ are trademarks of Digital Control

Incorporated.

69BPatents

The DigiTrak

SE™ Locating System is covered by one or more of the following U.S. Patents: 5,337,002;

5,633,589; 5,990,682; 5,990,683; 6,002,258; 6,005,532; 6,008,651; 6,014,026; 6,035,951; 6,047,783;

6,057,687; 6,095,260; 6,160,401; 6,232,780; 6,250,402; 6,396,275; 6,496,008; 6,525,538; 6,593,745;

6,653,837; 6,693,429; 6,756,784; 6,768,307; 6,838,882; 6,924,645; 7,061,244; 7,080,698; 7,154,273;

7,159,672; 7,167,005; 7,176,690; 7,304,479; 7,309,990; 7,345,486. Sale of a DigiTrak

SE™ receiver

does not convey a license under any patents covering the DigiTrak

transmitter or underground drill

housing. Other patents pending.

70BLimited Warranty

All products manufactured and sold by Digital Control Incorporated (DCI) are subject to the terms of a

Limited Warranty. A copy of the Limited Warranty is included with your DigiTrak

SE™ Locating System; it

can also be obtained by contacting DCI Customer Service, 800-288-3610 or 425-251-0559, or by

connecting to DCI's website, www.digitrak.com.

71BImportant Notice

All statements, technical information, and recommendations related to the products of DCI are based on

information believed to be reliable, but the accuracy or completeness thereof is not warranted. Before

utilizing any DCI product, the user should determine the suitability of the product for its intended use. All

statements herein refer to DCI products as delivered by DCI and do not apply to any user customizations

not authorized by DCI nor to any third-party products. Nothing herein shall constitute any warranty by DCI

nor will anything herein be deemed to modify the terms of DCI’s existing Limited Warranty applicable to all

DCI products.

72BFCC Compliance Statement

This equipment has been tested and found to comply with the limits for Class A and Class B digital

devices, pursuant to Part 15 of the Rules of the Federal Communications Commission. These limits are

designed to provide reasonable protection against harmful interference in a horizontal directional drilling

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications or

inaccurate readings on your DCI locating equipment. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or tele-

vision reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

 Reorient or relocate the DigiTrak

SE™ receiver.

 Increase the separation between the problematic equipment and the DigiTrak

SE™ receiver.

 Connect the equipment into an outlet on a different circuit.

 Consult the dealer for help.

Changes or modifications to the DCI equipment not expressly approved and carried out by DCI will void

the user’s Limited Warranty and the FCC’s authorization to operate the equipment.