User's Manual

Receiver
20 DigiTrak
®
SE™ Operator’s Manual
Calibration Menu
The calibration menu allows you to calibrate the receiver to the transmitter with the transmitter above
ground (1-point calibration at a distance of 10 ft or 3 m) or below ground (2-point calibration). When you
select the calibration menu, the 1PT CAL option is highlighted for selection as shown below.
Receiver Calibration Menu
Clicking the trigger will toggle between the 1PT CAL option (the preferred method) and the 2PT CAL
option (in-ground calibration). Hold in the trigger when the desired menu item is highlighted or wait 8
seconds to exit the menu.
Do not calibrate if:
 You are within 10 ft (or 3 m) of metal structures, such as steel pipe, chain-link fence, metal siding,
construction equipment, automobiles, etc.
 The receiver is over rebar or underground utilities.
 The receiver is in the vicinity of excessive electrical interference as described in the Safety
Precautions and Warnings section at the beginning of this manual.
 The transmitter is not turned on. See the Transmitter section for information on installing batteries
and verifying signal.
 The transmitter is not installed in the housing. See “Transmitter Housing Requirements” in the
Transmitter section.