User's Manual

Receiver
DigiTrak
®
SE™ Operator’s Manual 27
Roll Offset Menu
Click the trigger to toggle between the two options. Hold the trigger when the desired option is
highlighted.
After the activate roll offset option is selected, the following screen will appear. Once this screen has been
accessed, you will have 8 seconds to click the trigger or you will be returned to the locate screen with no
change to the roll offset.
Activate Roll Offset
You must then physically rotate the drill head to its 12 o’clock position, as indicated by the images at the
bottom of the screen. Then click the trigger to activate the roll offset and automatically be returned to the
locate screen. If you do not click the trigger within 8 seconds, you will be returned to the locate screen
with no change to the roll offset. Roll offset is denoted by a hollow dot in place of the solid dot on the
clock face and the letters “RO” next to the clock.
NOTE: If using an MFD or FSD remote with SE software, the RO symbol will appear next to the clock
on the remote display as well. If using a Mark Series remote, no RO symbol will appear but the
roll value will be the offset value shown on the SE receiver.
Activate Roll Offset
(Shown Highlighted)
Disable Roll Offset
Transmitter Roll
Drill Head at
12 o'clock Position