User's Manual

Receiver

30 DigiTrak

SE™ Operator’s Manual

Hold the trigger in to advance to the screen shown below where you can set the reference depth value. At

this screen, you can click through the available fields, which are the foot or meter (ft/m) setting, the inches

or centimeters (in./cm) setting, and the checkmark (used to confirm the reference depth setting).

Set Reference Depth Value Screen (Foot or Meter Setting Highlighted)

In this example, the line under the number 2 indicates that the ft/m setting is highlighted. To change this

setting, hold in the trigger until a box appears around the number 2, as shown below. Once you see the

box, click the trigger to increase (in 1-ft or 1-m increments) to the desired number. Once you reach the

desired number, hold in the trigger, and the box will turn back into an underline under the ft/m setting.

Set Reference Depth Value Screen (Foot or Meter Setting Selected)

To change the in./cm setting, click the trigger to move the underline to the in./cm position, and then hold

the trigger in until a box surrounds the number. Once you see the box, click the trigger to increase in 1-in.

or 2-cm increments. Once you have the desired in./cm setting, hold in the trigger.

Underline indicates

value is highlighted

and can be changed.

Checkmark is used

to confirm the

reference depth

setting.

Foot or

Meter Setting

Inches or

Centimeters Setting