User's Manual

Receiver
DigiTrak
®
SE™ Operator’s Manual 31
NOTE: If you click past 11 in. or 98 cm, then the number in the ft/m setting will automatically increase.
Also, if you click past your desired value, you can either click through the maximum values
(99 ft or 30 m), or wait 10 seconds to exit the menu and then reenter the Remote Steering
menu, to start back at the default value (2 ft or 0.50 m).
To set the displayed value as your reference depth, click the trigger to move the underline underneath the
checkmark and hold the trigger in. A confirmation tone will sound.
For information about how to position the receiver ahead of the tool for target steering, see the Remote
Steering section.
NOTE: When remote steering is not active, a Mark Series remote display will show the steering
indicator at the far right. See the Remote Steering section for more information.
Display Screens
The basic receiver displays include the locate mode screen, the depth mode screen, and the predicted
depth screen. These are presented below. For more information regarding these screens and for detailed
locating instructions, please see the Locating section.
Locate Mode Screen
When a transmitter is in range, the locate mode screen provides real-time data about the transmitter’s
location, temperature, pitch, roll, and signal strength. The roll/pitch meter shows the quality of the signal
from the transmitter. The locate mode screen is the default screen setting.
Receiver Locate Mode Screen
2
Locating Target
(FLP or RLP)
Transmitter Signal
Strength
Roll/Pitch Update
Meter
Roll Indicator
Transmitter
Temperature
Transmitter Pitch
Receiver