User's Manual

DIGITAL CONTROL INCORPORATED
DigiTrak
®
SE™ Operator’s Manual 41
Battery Charger
General Description
SE Battery Charger System
The DCI SE Battery Charger (SBC) system includes an AC power cord, a power unit attached to the
battery charger, and two rechargeable NiMH battery packs. The battery packs are used to power the SE
receiver. Only DCI battery packs should be used in the SE receiver. Using another type of battery could
result in damage and voiding of the warranty. Although the SE receiver can accept a DCI lithium-ion
battery, you cannot charge a lithium-ion battery pack in the SBC charger.
The battery charger operates from an AC (100–240 V, 50–60 Hz, 0.35 A max.) power source. The AC
power cord that is shipped with your system is standard to your global area of operation.
A fully charged DCI NiMH battery pack will power an SE receiver for approximately 6 hours before
recharging is necessary. A battery will take approximately 3 hours to recharge. If power to the charger is
interrupted while charging a battery, the charger will reset and start a new charge cycle when power is
again supplied.
NOTE: The DCI NiMH battery pack must be fully charged and fully discharged twice before optimum
battery performance can be expected.
This battery charger is only designed for indoor use and should not come into contact with water or dust.
To avoid overheating, the charger should not be covered when it is in use.
AC Power
Cord
DCI NiMH
Power Unit
DCI NiMH
Battery Packs
DCI NiMH
Battery Charger